Hemp Oil Soap Mold (3 Round Bars)- Marijuana Hemp CBD Soap Mold
Hemp Oil Soap Mold (3 Round Bars)- Marijuana Hemp CBD Soap Mold
Couldn't load pickup availability
DESCRIPTION
DESCRIPTION
Hemp Oil Soap Mold Round Soap Bars- Marijuana Hemp CBD Soap Mold
This round soap mold displays hemp with its jagged leaves and the words ‘HEMP OIL’ in capital block letters. Commonly used for melt and pour soap made with hemp soap bases or cold process soap made with hemp seed oil or hemp seed butter blend.
Use with our Marijuana fragrance oil!
Common Uses:
Melt & Pour Soap. Cold Process Soap. Lotion Bars.
Points of Interest:
Manufacturer: Milky Way Molds
Material: Clear PVC (Not Approved for Food Contact)
Country of Origin: United States
Milky Way Soap Molds can tolerate temperatures of 135-145 degrees F. Above these temperatures, warping may occur. Soap is easiest to release 12-24 hours after cooling.
Wash molds in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.
Country Of Origin: United States
|
Material: Plastic |
Style: Bar |
|
Avg. Bar Weight: 4.8 oz |
Bar Cavities: 3 |
|
Bar Depth: 1.125" |
Bar Length: 3" |
|
Bar Width: 3" |
Max Temperature: 145º F |
|
Mold Capacity: 14.4 oz |
Directions:
Melt & Pour Soap: Pour melted soap at a temperature no hotter than 135ºF into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.
Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.
Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 135ºF. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold.
Care:
Wash in warm, sudsy water. Please avoid the dishwasher because that can warp your molds or make them brittle.
CARE INSTRUCTIONS
CARE INSTRUCTIONS
Wash molds in warm, sudsy water. Do not wash plastic molds in the dishwasher, as it can make them brittle.
Fragrance oils and essential oils, citric acid etc will degrade plastic molds, so it is best to wash out and dry immediately after use. With proper care, you can get 1000+ uses from a single mold.
- Buy More, Save More!
We now offer tiered discounts on select molds! You can mix and match different molds* to receive the discount. Discount is automatic - no coupon required! See table below for details:
